Rosco Flamex WD (Wood) 3.79L

The method of application and the amount of Roscoflamex WD required for sufficient treatment varies with the materials in use.

• Dipping: This is the most efficient method of impregnation. Immerse completely for ten minutes, and hang to dry.
• Brushing: Using a wide lay-in brush, brush the Flamex solution into the fibers of the material being treated. Brush in the solution using a criss-crossing pattern to insure adequate absorption.
• Spraying: In a spray application, it is very important that an adequate amount of the Flamex be absorbed. In calculating the amount of solution needed, remember that a substantial portion of the spray will not fall on the fabric. Use a Hudson-type sprayer with a medium nozzle setting. For best results, hang the material to be treated and spray in a back and forth pattern starting at the bottom and working your way up to the top of the fabric sample. Over saturating the fabric may cause it to stiffen or otherwise alter its hand. ALWAYS treat a test sample to determine how the fabric will react and to test for effective flame retardance.

Storage

Store Flamex products in non-metallic containers. When metal sprayers are used, they should be thoroughly cleaned immediately after use, including nozzles and accessories. Avoid use of metal buckets or paint containers when possible.

Disclaimer

Roscoflamex WD compares to original Roscoflamex W40 Read carefully the instructions supplied with any Flamex product. Rosco offers these products in good faith, but without guarantee of any type, since materials treated and methods of application are beyond the control of the manufacturer. You should determine suitability of the Flamex product for the intended use and always test before using.