Polyvine Heavy Duty Floor Varnish Satin
Backorder: Available in 5 days (26/11/2024) if ordered today
£35.52 inc VAT
Free Saver Delivery on orders over the value of £45
Ultra tough crystal clear protection for interior floors.
An ultra hard, high quality coating with a satin or dead flat finish that dries to a crystal clear film with extremely good sanding properties allowing a very high quality of finish to be obtained. Formulated for floors and areas of high wear. When using dead flat finish, if a very high level of durability and stain resistance is required, apply one or two coats of Floor Varnish Satin Finish followed by one or two coats of Floor Varnish Dead Flat Finish.
Ideal for
- Wooden floors
- Cork tiles
- Stone
- Slate
- Brick
- Quarry tiles
- Wooden worktops
Key Features of Polyvine Heavy Duty Floor Varnish Satin
Unique qualities
- Dries fast cures fast
- Highly heat and water resistant
- Ultra hard
- Clear as glass
- Good resistance to alcohol, stains and chemicals
- Resistant to heel marks
- Sands to a high-grade finish
- Easy to apply
- Wash brushes in water
Specifications
At a glance
- Drying time: 30-60 minutes
- Recoat time: 1-2 hours
- Curing time: 16 hours in ideal conditions. Allow 48 hours before heavy use.
- Coverage: 10-20 square metres per litre
Application and advice
Preparation
Thoroughly sand in the direction of the grain to remove all traces of old finishes and dirt, oil and contamination. Old floors can be impregnated with wax and grease - this will cause failure and must be completely removed. On new wood or if the old finish is in good condition, lightly sand to provide a key. Thoroughly clean after sanding.
Application
Ensure the product is well mixed. Apply 3 coats of varnish. On new wood and porous surfaces dilute the first coat 10% with water. Lightly sand wood in between applications to remove any raising of the grain that may have occurred.
Caution
Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats.
Do not apply over uncured oil paints.
Storage
Protect from extremes of temperature during storage and application. Do not use below 5 degrees C.
Health, safety and the environment
Non-hazardous. Ensure good ventilation. Keep out of reach of children. Contact with eyes - wash immediately with warm water. Remove excess from tools and mixing vessels before washing in warm soapy water. Do not empty into drains or watercourses.
Related Products
Polyvine Varnish & Paint Remover 1L
£24.60 inc VAT
Ultra-Low in VOC and Solvent Varnish & Paint Remover
Frequently Bought Together
Firecheck™ 750ml Trigger Spray Bottle
£16.80 inc VAT
Water based fire proofing spray for Fabrics and Paper
